Loading ...
Loading ...
Loading ...
8
Connect Hoses and Water Supply
NOTICE DO NOT run the pump without the water supply
connected and turned on.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
1. Uncoil high pressure hose (A) and attach end of hose to base
of spray gun (B). Tighten by hand.
B
A
WARNING The high pressure stream of water that this
equipment produces could cut through skin and
its underlying tissues, resulting in serious injury
and possible amputation.
Spray gun traps high water pressure, even when motor is
stopped and water is disconnected, which could result in
serious injury.
• NEVER aim spray gun at people, animals, or plants.
• ALWAYS point spray gun in safe direction, squeeze spray
gun trigger to release high pressure, every time you turn off
pressure washer.
2. Attach end of high pressure hose (A) to high pressure outlet
(C) on pump. Tighten by hand.
3. Run water through your garden hose for 30 seconds to clean
out any debris.
NOTICE DO NOT siphon standing water for the water supply. Use
ONLY cold water (less than 90°F (32°C)).
4. Before connecting garden hose (D) to water inlet (E), inspect
inlet screen (F). Clean screen if it contains debris or have it
replaced if damaged. DO NOT run pressure washer if inlet
screen is damaged.
Connect to Individual Branch Circuit Only.
IF CONNECTION IS MADE TO A POTABLE WATER SYSTEM,
THE SYSTEM SHALL BE PROTECTED AGAINST BACKFLOW.
NOTICE Using a One Way Valve (vacuum breaker or check
valve) at pump inlet could cause pump or inlet connector
damage.
• There MUST be at least 10 ft. (3 m) of unrestricted garden hose
between the pressure washer inlet and any device, such as a
vacuum breaker or check valve.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
5. Connect the garden hose (D) (not to exceed 50 ft. (15 m) in
length) to the water inlet (E). Tighten by hand.
WARNING Risk of eye injury.
Spray could splash back or propel objects resulting
in serious injury.
• Always wear properly rated eye protection such as safety
goggles or face shield comply with ANSI Z87.1, while
spraying. (safety glasses do not provide full protection.)
when using or in vicinity of this equipment. NEVER substitute
safety glasses or drycondition goggles for indirect vented
safety goggles.
• NEVER substitute safety glasses or dry-condition
goggles for indirect vented safety goggles..
F
6. Turn ON the water, open the lock (F) on the gun and
squeeze the trigger for 30 seconds to purge the pump system
of air and impurities.
D
E
C
A
Loading ...
Loading ...
Loading ...