Loading ...
Loading ...
Loading ...
6
Assembly
Read entire operator’s manual before you
attempt to assemble or operate your new electric
pressure washer.
Your electric pressure washer requires some assembly but
is quickly ready for use.
Items Not Included
• Garden hose
Unpack Electric Pressure Washer
1. Remove everything from carton.
2. Ensure you have all included items prior to assembly
Items Included in the Carton
• Main unit
• Handle
• Wheels (2) and hardware
• Spray gun
• High pressure hose
• Quick Connect (QC) spray tips (3)
- Yellow nozzle 15°
- Black Foam nozzle
- Turbo nozzle
• Spray wand
• Detergent tank
• Operator’s Manual
Check all contents. If any parts are missing or damaged, call the
customer service .
Become familiar with each component before assembling the
electric pressure washer. Identify contents with the illustration
shown in Features and Controls.
Prior to Operation
1. Read and perform the following instructions while paying
close attention to all warnings and notices.
NOTICE Connect ONLY to water source capable of supplying
a minimum of 5 gpm (18.9 lpm) and no less than 20 psi (1.38
bars)at the electric pressure washer end of garden hose. Inspect
all equipment, hoses and accessories thoroughly before each
use, DO NOT use if damaged.
• ONLY use branded accessories intended for use with this
product.
• For optimum performance, DO NOT use a garden hose that
exceeds 50 feet in length (30 feet max if water source is a
well).
• Replace only with original equipment parts.
Lubricate O-Rings
Lubrication of o-rings is extremely important for installation and
operation. The use of a lubricant (petroleum or synthetic grease)
during assembly helps seat o-rings properly and provides an
improved seal. It also helps protect the o-ring from damage by
abrasion, pinching or cutting and extends the life of the o-ring.
NOTICE ALWAYS apply a small amount of lubricant on o-rings
prior to assembling
the garden hose to the pump (A),
high pressure hose (pump end) (B),
high pressure hose (gun end) (C),
spray wand (gun end) (D).
Lubricate all connections shown below, following these
instructions:
1. Inspect and clean connecting surfaces prior to lubrication and
assembly.
2. Use lubricants sparingly during assembly; a light film is all that
is required.
3. Use a small brush or cotton swab to apply grease directly to
o-rings where they are not accessible (QC fitting, M22 fitting).
A
B
D
C
Loading ...
Loading ...
Loading ...