Loading ...
Loading ...
Loading ...
12
How to Stop Your Electric Pressure
Washer
The electric pressure washer motor runs only when the
ON/OFF switch is in the ON (I) Position. To stop the electric
pressure washer and turn off the motor:
1. Release spray gun trigger.
2. Press the master ON/OFF switch to the OFF (O) position.
3. Turn off water supply.
4.
ALWAYS point spray gun in a safe direction and squeeze spray
gun trigger to relieve built up pressure in the unit.
WARNING The high pressure stream of water that this
equipment produces could cut through skin and
its underlying tissues, resulting in serious injury
and possible amputation.
Spray gun traps high water pressure, even when motor is
stopped and water is disconnected, which could result in
serious injury.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• ALWAYS point spray gun in safe direction, squeeze spray
gun trigger to release high pressure, every time you turn
off pressure washer.
5.Disconnect GFCI plug from outlet and coil power cord.
6.Flush detergent tank (if used) by rinsing out all remaining
detergent.
7. Coil and store power cord, high pressure hose, spray gun
and accessories.
Spray Tips
There are three spray tips supplied with the pressure washer. The
turbo spray tip whirls a powerful pin-point jet of water for
intense cleaning. The soap tip is for general soap applications,
and the high pressure tip is for various high pressure
applications.
Black Detergent Nozzle - Low Pressure Foamer .
Use to apply detergent.
Yellow Cleaning Nozzle - High Pressure 15°
Siding / Patios / Decks / Driveways / Garage
Floors
Intense Cleaning Turbo Paint Removal / Oil Stains /
Rust Removal
Usage Tips
• For most effective cleaning, keep spray tips 8 - 24 inches aw
ay
from cleaning surface.
• If spray tips get too close, especially using a high pressure spray
trip, you may damage surface being cleaned.
• DO NOT get closer than 6 inches when cleaning tires.
Applying Detergent
WARNING Chemical Burn Hazard.
Chemicals could cause burns resulting in
death or serious injury.
• Always wear indirect vented (chemical splash) safety
goggles marked to comply with ANSI Z87.1 when using
chemicals.
• DO NOT substitute safety glasses or dry-condition goggles
for indirect vented safety goggles.
• DO NOT use caustic liquid with electric pressure washer.
• Use ONLY pressure washer safe detergents/soaps. Follow all
manufacturers instructions.
1. Review use of spray tips in Spray Tips.
2. Prepare your detergent solution as required by job to be
performed.
3. Check that detergent siphoning tube (transparent) is
connected at botton of detergent tank.
4. Install soap tip.
NOTICE Detergent cannot be applied with turbo or high pressure
spray tips.
5. Make sure garden hose is connected to water inlet. Check
that high pressure hose is connected to spray gun and high
pressure outlet. Turn on water.
NOTICE You must attach all hoses before you start the pressure
washer.
6. Start the pressure washer as instructed in Start Pressure
Washer.
7. Apply detergent to a dry surface, starting at lower portion
of area to be washed and work upward using long, even,
overlapping strokes.
8. Allow detergent to “soak in” for 3-5 minutes before washing
and rinsing. Reapply as needed to prevent surface from drying.
To prevent streaking, Do Not allow detergent to dry on surface.
Loading ...
Loading ...
Loading ...