Loading ...
Loading ...
Loading ...
20
How to pair (sync) camera using match code:
1. Connect the camera to your NVR via
Ethernet cable, and power on both of
the NVR system & the camera. The
Ethernet port at the end of camera will
blink, as shown in image below.
2. Right click your mouse to bring up the
main menu, then click ‘Video Manage’.
From the video manage click ‘Refresh’
on upper right and wait about 20~30
second, and you’ll see the camera
displays in upper chart.
3. Once you see the camera listed on the
top chart, click on the ‘Match Code’ to
start pairing the camera to the system.
4. When the system is done adding the
camera, click on the ‘Exit’ to stop the
pairing process.
5. Once you are done the camera you
have added should be listed at the
bottom chart indicating the camera has
been sync to the system.
6. When you are done click ‘OK’ to save &
exit the video manage, and unplug the
Ethernet cable from the camera.
Note:
Connection Success: Camera is paired
to NVR system successfully. You should
be able to see the camera feedback on
the monitor.
NO Video Source: Available camera slot
where you can add new or re-pair
existing camera.
IPC Disconnect: Camera is paired to the
NVR system, but not yet connected (Ex.
Camera is out of range or not yet
powered on).
Camera needs to be in the NVR’s Wi-Fi
range.
Loading ...
Loading ...
Loading ...