Loading ...
Loading ...
Loading ...
OPERATINGTHETRIMMER
•Insertthefullychargedbatteryintothe
trimmeruntilyouhearit"click"intoplace
asshowninfigureH.
•Totumthetrimmeron,pushthelock off button (1), across and, then
squeeze the trigger switch (2) shown in figure t. In a few seconds or
less you'll hear the nylon line being cut automatically to the proper
]eegth.
• To turn the tool off, release the trigger. _) fl_YHI .Y
• Hold tdmmer with two hands and slowly swing
trimmer side-to-side as shown in figure J.
POWER COMMAND TMFEATURE
The Power Command feature (3) is located
on the tool handle as shown in figure I. It
allows you to optimize the tools
performance and boost the power as needed.
• Operate in "Normal" mede for most trimming
needs. (Longer runtime will be achieved.)
• Switch to "Boost" mode on the fly vTflen tall, wet or thick conditions are
present.
EDGING MODE
•_-WARNING: R..... battery
pack from tool before attempting to make
any adjustment.
To convert for maintenance edging:
• Hold the trimmer with one hand and grasp the
housing.
• Push in on the release button (as shown in
figure K) and rotate the trimmer head until it
stops, (half turn).
• Release your hand. The tool is locked in the
edger position.
• To operate as a maintenance
edger, position trimmer above
sidewalk or other surface as shown
in figure M.
• To return to the trimming position,
turn the too] off, push in on the
release button and rotate the
trimmer head counter clockwise
until it stops. When using the tool in
the trimmer mode you may choose
to fold the wire edge guide up out of
the way
LINE FEEDING
Your trimmer uses .065 in. (1.65mm) diameter nylon line to cut grass
and weeds quickly and easily. In time, the tip of the nylon line will
become worn and the auto feed mechanism will automatically feed
and trim a fresh length of line.
The cutting line will wear faster if the cutting is done along sidewalks
or other abrasive surfaces or heavier weeds are being cut. The
automatic feed mechanism senses when more cutting line is needed
and feeds and trims the correct length of line whenever it is required.
Do not bump unit on ground in attempt to feed line or for any
other purpose.
REPLACING SPOOL
Black & Decker recommends that for optimal performance, use only
Black & Decker replacement spools (AF-100) which can be
purchased at many local tool retailers. If you need assistance
regarding accessories call 1-800-544-6986.
• Turn off the trimmer and remove the battery.
• Press the release tabs on the line spool
cover, as shown in figure N and remove
th...... by pulling it straight off. I_
Lift the spool of nylon line out of the hub RC-100-_
and clear any broken line or cutting Cap
debris from the spool area.
Loading ...
Loading ...
Loading ...