Loading ...
Loading ...
zLWAR NING : Somedustcreatedbythisproduct
contains chemicals known to the State of California to cause cancer,
birth defects or other reproductive harm. Some examples of these
chemicals are:
• compounds in fertilizers
• compounds in insecticides, herbicides and pesticides
• arsenic and chromium from chemically treated ]umber
To reduce your exposure to these chemicals, wear approved safety
equipment such as dust masks that are specialty designed to filter out
microscopic particles.
Extension Cord
Make sure your extension cord is #1good condition. When using an
extension cord be sure it is heavy enough to carry the current your
product will draw. An undersized extension cord will cause a drop in
line voltage resulting in loss of power and overheating. The following
table shows the correct size to use depending on cord length and
nameplate ampere rating. If in doubt, use the next heavier gauge.
The smaller the gauge number, the heavier the cord.
I Minimum Gauge for Cord Sets
Volts Total Length of Cord in Feet
120V O-25 26-5O 51-100 101-150
{0-7,6m) {7,6-15,2m) {15,2-30,4m) {30A-45,7m)
_40V O-5O 51-100 101-200 201-300
(0-15,2m) (15,2-30,4m){30,4_60,9m)(60,9-91,4m)Ampere
Iore Not more Amedcan W_reGauge
Rating
Than Than
o - 6 18 16 16 14
6 - 10 18 16 14 12
10 - 12 16 16 14 12
2 - 16 14 12 Not Recommended
Double Insulation
Double insulated tools are constructed throughout with two
separate layers of electrical insulation or one double thickness
of insulation between you and the tool's electrical system.
Tools built with this insulation system are not intended to be
grounded. As a result, your tool is equipped with a two prong
plug which permits you to use extension cords without concern
for maintaining a ground connection. NOTE; Double insulation does
not take the place of normal safety precautions when operating this
tool. The insulation system isfor added protection against injury
resulting from a possible electrical insulation failure within the tool.
REPLACEMENT PARTS: When servicing all tools, USE IDENTICAL
REPLACEMENT PARTS. Repair or replace damaged cords.
The label on your tool may include the following symbols.
V................ volts A .................... amperes
Hz .............. hertz W .................. watts
rain ............ minutes % .................. alternating current
- - - . ......... direct current no .................. no load speed
[] .............. Class II Construction @ .................. earthing terminal
............ safetyalertsymbol .../min ............ revolutions
per minute
±SAFETY WARNINGS AND
INSTRUCTIONS
CHARGING
1. This manual contains important safety and operating instructions.
2. Before using battery charger, read all instructions and cautionary
markings on (1) battery charger, (2) battery pack, and (3) product
using battery pack.
3. % CAUTION: To reduce the risk of injury, charge only
Black & Decker Battery Packs. Other types of batteries may burst
causing personal injury and damage.
4. Do not expose charger to rain or snow.
5. Use of an attachment not recommended or sold by Black & Decker
may result in a risk of fire, electric shock, or injury to persons.
4
6. To reduce risk of damage to electric plug and cord, pull by plug 12. DO NOT incinerate battery packs even if they are severely
rather than cord when disconnecting charger, damaged or completely worn out.
7. Make sure cord is located so that it will not be stepped on, tripped 13. Do not incinerate the battedes. Theycanexplodeinafire. A
over, or otherwise subjected to damage or stress, small leakage of liquid from the battery ceils may occur under
8. An extension cord should not be used unless absolutely extreme usage, charging or temperature conditions. This does
necessary. Use of improper extension cord could result in a risk not indicate a failure. However, if the outer seal is broken and
of fire, electric shock or electrocution, this leakage gets on your skin:
a. Two-wire cords can be used with 2-wire or 3-wire extension a. Wash quickly with soap and water.
cords. Only round jacketed extension cords should be used, and b. Neutralize with a mild acid such as lemon juice or vinegar.
we recommend that they be listed by Underwriters Laboratories c. If the battery liquid gets in your eyes, flush them with clean water
(U.L.). If the extension is to be used outside, the cord must be for a minimum of 10 minutes and seek immediate medical
suitable for outdoor use. Any cord marked for outdoor use can attention. MEDICAL NOTE; The liquid is a 25-35% solution of
also be used for indoor work. The letters "W" or "WA" on the cord potassium hydroxide.
jacket indicate that the cord is suitable for outdoor use.
b. An extensi ...... d must h.... deduate wire size (AWG or IMPORTANTCHARGINGSAFETY
American Wire Gauge) for safety, and to prevent loss of power
and overheating. Th ..... ],er the gaug ...... bet of the wire, the INSTRUCTIONS
greater the capacity of the cable; that is, 16 gauge has more
capacity than 18 gauge. When using more than one extension to CHARGING PROCEDURE
make up the total length, be sure each extension contains at
]east the minimum wire size. THE BATTERY PACK IS NOT FULLY CHARGED AT THE
CHART FOR MINIMUM WIRE SIZE (AWG) OF EXTENSION CORDS FACTORY, CHARGE BATTERY PACK FOR AT LEAST 9 HOURS
NAMEPLATE RATING AMPS - O- 10.O BEFORE USE,
Total Extension Cord The charger is designed to use
standard household 120 volt
Length (ft) 0-25 26-50 51-10O 101-150 60 Hz power.
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m) 1. Plug the charger into any
Wire Gau qe 18 16 16 14 standard 120 Volt 60 Hz
eiectedaJ outlet.
9. Use only the supplied charger when charging your unit. The use
of any other charger could damage the battery pack or create a 2. Slide the charger onto the
battery pack as shown in
hazardous condition, figure A and let the battery
10. Use only one charger when charging, pack charge initially for 11 hours. After the initial charge, under
11. Do not attempt to open the charger or the unit. There are no normal usage, your battery pack should be fully charged in
customer serviceable parts inside. Return to any authorized 9 to 11 hours.
Black & Decker service center. 2a) During charging the green LED will appear.
5
Loading ...
Loading ...
Loading ...