Loading ...
Loading ...
Loading ...
48
STEP 4 INSTALLATION WITH
HOUSEHOLD WATER
FILTRATION SYSTEM
Skip this step if you do not have a household water
filtration system
If the water supply to the refrigerator is from any
household water filtration system, the filter cartridge
should be removed. For better ice and water
performance, remove the filter and install the filter
bypass plug.
STEP 5 INSTALL SIDE PANELS
Skip this step when not using side panels.
If you are using 1/4” side panels, they should be
inserted into the case trim. Fasten the panels to the
refrigerator with stick-on hook and loop fastener strips
before setting the refrigerator in place.
STEP 6
ANIT-TIP PROCEDURE
WARNING
Tip Over Hazard.
These refrigerators are top heavy, especially with any
doors open, and must be secured to prevent tipping
forward which could result in death or serious injury.
Read and follow the entire installation instructions for
securing the refrigerator with the anti-tip system.
ADVERTENCIA
Risque de
basculement
Ces réfrigérateurs présentent une partie
supérieure lourde, en particulier avec une
porte ouverte; ils doivent donc être fixés pour
prévenir le basculement vers l’avant et le risque
concomitant de blessure grave ou fatale. Lisez
et suivez les instructions d’installation complètes
pour l’installation du système anti-basculement.
Installation Instruction - Stainless Steel Installation
Filter Bypass
Plug
Rotate Counterclockwise
To Remove
• Cut a 2” x 4” block, 35” long and secure the block
to the mounting brackets provided using #12 or #14
wood screws.
• Secure the bracket
with wood block to
the back wall so that
it is 84” from the
finished floor. Use
#12 or #14 wood
screws. See the
illustration.
• The screws must
penetrate at least
one inch into the
vertical wall studs.
• If metal wall studs, use self-tapping sheet metal
screws in place of wood screws.
IMPORTANT: When the refrigerator is installed under
a soffit or if there is not enough height for this method
of security, brackets cannot be used. Proceed to step
7 to level the refrigerator and then to step 8 to secure
refrigerator to cabinets. The refrigerator must be
secured to prevent tipping.
Connect power cord:
• Before pushing the refrigerator into the opening, plug
the power cord into the receptacle. Open the grille
panel and reach into the opening at the back to grasp
the power cord. Pull the power cord into the opening
as you push the refrigerator back.
• Gently push refrigerator into the opening with hands
against front corners.
STEP 6 ANIT-TIP PROCEDURE (Cont.)
Loading ...
Loading ...
Loading ...