Loading ...
Loading ...
Loading ...
STEP 8 LEVEL REFRIGERATOR
All models have 4-point leveling. The front is supported
by leveling legs, the rear is supported by adjustable
wheels. Both are accessible from the front of the
refrigerator.
• To level the back of the refrigerator, turn the 7/16”
hex nut located above the front wheels. Turn
clockwise to raise or
counterclockwise to lower
the refrigerator.
• For front leveling, use a
1-1/4” open-end wrench.
• Adjust height of refrigerator
to match installation cutout
opening 84-1/2”. The
refrigerator should be level
and plumb with cabinetry.
NOTICE: The rear leveling wheels and front leveling
legs are limited to a maximum height adjustment
of 1”. If the installation requires more than 84-1/2”
height, the installer should elevate the refrigerator
on a sheet of plywood or runners. Cabinetry trim
could also be added across the top of the opening
to shorten the opening. If you attempt to raise the
refrigerator more than 1”, you will damage the
front leveling legs and the rear leveling wheels.
Make adjustments in small increments.
34
Installation Instructions - Flush Installation
We recommend units for flush installation be
installed under a soffit. If this is not possible, follow
these instructions using the mounting brackets.
• Cut a 2” x 4” block, 35” long and secure the block
to the mounting brackets provided using #12 or #14
wood screws.
• Secure the bracket with wood block to the back wall
so that it is 84” from the finished floor. Use #12 or #14
wood screws. See the illustration.
• The screws must
penetrate at least
one inch into the
vertical wall studs.
• If metal wall studs
then use self-
tapping sheet metal
screws in place of
the wood screws
to secure the block
and brackets to the
wall.
STEP 7 ANIT-TIP PROCEDURE
(continued)
Loading ...
Loading ...
Loading ...