Loading ...
Loading ...
Loading ...
16
STEP 7 LEVEL REFRIGERATOR
All models have 4-point leveling. The front is
supported by leveling legs, the rear is supported by
adjustable wheels. Both are accessible from the front
of the refrigerator.
• To level the back of the refrigerator, turn the 7/16”
hex nut located above the front wheels. Turn
clockwise to raise or counterclockwise to lower the
refrigerator.
• For front leveling, use a
1-1/4” open-end wrench.
• Adjust height of refrigerator
to match installation cutout
opening 84-1/2”. The
refrigerator should be level
and plumb with cabinetry.
NOTICE: The rear leveling
wheels and front leveling legs are limited to a
maximum height adjustment of 1”. If the installation
requires more than 84-1/2” height, the installer should
elevate the refrigerator on a sheet of plywood or
runners. Cabinetry trim could also be added across
the top of the opening to shorten the opening. If you
attempt to raise the refrigerator more than 1”,
you will damage the front leveling legs and the
rear leveling wheels. Make adjustments in small
increments.
Installation Instructions - Standard Installation
STEP 8 ALTERNATE ANTI-TIP
PROCEDURE
The refrigerator must be secured to prevent tipping.
• Raise the grille panel to access case trim.
• Use a 3/16” bit to drill four evenly spaced clearance
holes through the metal top case trim.
• Use a 1/16” bit to drill to pilot holes through the metal
clearance holes and into the wood soffit. The holes
should be centered in the soffit or a 3/4” min. wood
brace. The brace spanning the enclosure must be
securely fastened to cabinets on both sides.
• Install four, 1-1/2” drywall screws into the pilot holes.
• Drill screws into adjacent cabinets through side case
trim.
Loading ...
Loading ...
Loading ...