Loading ...
Loading ...
Loading ...
STEP 11 INSTALL 1/4” FRAMED PANELS
Install door panels:
• Open the door to 90°. Remove the 6 Phillips head
screws from the door handle.
• Remove the handle. Retain all screws.
• Remove the 6 screws holding the trim, then lift off the
trim. Retain the screws.
• Slide the framed panel into the door trim.
Dispenser Models Only:
• The dispenser controls protrude beyond the face of the
freezer door. To avoid damage to the dispenser, the
trim at the top of the door should be removed.
• Remove the screws holding the top trim in place.
• Place the freezer panel into the bottom channel and
slide into the hinge side trim.
• Reinstall the top trim piece with screws.
• There are two sets of holes in the handle side trim.
Replace the handle side trim by installing the original
screws in the FRONT screw holes.
• Secure the handle to the door using the REAR screw
holes.
• Follow the same procedures to install the opposite
panel.
• Check to be sure the handles are evenly aligned with
each other at the top. To adjust, loosen the handle
screws and slide up or down. Tighten the screws.
NOTE: Aluminum cover trim is supplied for use with
custom handles on overlay panels. It is not intended for
use with 1/4” panels. Discard the cover trim when using
1/4” framed panels.
Go to Step 12A for Overlay Panels
Supplied Handle
Shown in 1/4”
Panel Position
18
Installation Instructions - Standard Installation
Loading ...
Loading ...
Loading ...