Loading ...
Loading ...
Loading ...
TEC_TM_156 | REV. D | EN 9/12/2022 Page 61 of 9615 & 24 INCH INSTALL GUIDE
24 INCH
A
B
C
D
E
F
CHANGING CO
2
GAS CYLINDER
CAUTION: ALWAYS FOLLOW THESE INSTRUCTIONS
WHEN YOU REPLACE A CO
2
GAS CYLINDER:
1. Close cylinder valve A.
2. Remove tap head D from the barrel. Pull the
pressure release ring on body of the tap to release
pressure remaining in line. (DO NOT close regulator
shutoff C).
3. Remove or loosen regulator key B by turning
counter clockwise.
4. Remove the regulator from used cylinder at E.
5. Remove the dust cap from new gas cylinder at
outlet E and clear dust from the outlet by opening
and closing valve A quickly using appropriate
wrench.
6. Attach the regulator to the new cylinder at outlet E.
(use new fiber/plastic washer, if required).
7. Completely open valve A.
8. Close valve C.
9. Adjust the regulator key B by turning clockwise
to set pressure. Check setting by opening C and
pulling and releasing the ring F on the pressure
release valve on the body of the tap).
10. Tap the barrel at D with valve C open.
NOTE: DON'T LAY CO
2
CYLINDERS FLAT.
DON'T DROP CO
2
CYLINDERS.
IT REQUIRES 1/2 POUND (0.23 KG) OF CO
2
TO
DISPENSE 1/2 BARREL OF BEER AT 38˚F (3.3˚C)
WITH 15 PSI (1.03 BAR) OF PRESSURE ON THE
BARREL.
CO
2
REGULATOR PRESSURE
ADJUSTMENT
Increasing Pressure
1. Close regulator shut-off C.
2. Turn the regulator key B clockwise and adjust
setting.
3. Tap the gauge for an accurate reading.
4. Open regulator shut-off C and draw beer.
WARNING: Contents under pressure.
Take care when handling filled CO
2
tanks. If unfamiliar with using CO
2
tanks
and/or regulators, seek information
from your local distributor or brewer
representative before proceeding.
Decreasing Pressure
1. Close regulator shut-off C.
2. Untap the barrel at D and to bleed line, activate
the tap handle. Leave it in the open position.
3. Slowly open regulator shut-off C and
simultaneously turn regulator key B counter-
clockwise to zero reading.
4. Close regulator shut-off C and set pressure by
turning regulator key B clockwise. Check the
setting by opening and closing valve C.
5. Close the tap head D. (Put in OFF position).
6. Tap the barrel at D and open regulator shut-off C.
CABINET SETUP
15 INCH
A
B
C
D
E
F
PARTS KEY
A Cylinder Valve
B Regulator Key
C Regulator Shut-off
D Tap Head
E CO
2
Cylinder Outlet
F Ring
Loading ...
Loading ...
Loading ...