Loading ...
Loading ...
Loading ...
TEC_TM_156 | REV. D | EN 9/12/2022 Page 37 of 9615 & 24 INCH INSTALL GUIDE
CABINET SETUP
STACKING KIT INSTALLATION
KIT CONTENTS
• (1) Louver Grill (stainless models)
• (2) Stacking Brackets
• (4) 1/4" Hex Head Screws
REQUIRED TOOLS
Required tools include (but may not be limited to)
the following:
• Floor protector
• Level
• 1/4" Hex Head Driver
• Drill
RECOMMENDED – This procedure may
require assistance.
RECOMMANDÉ – Cette procédure peut
nécessiter une assistance.
WARNING – Units may pose a tipping
hazard during stacking kit installation
or when moving the stacked units.
ATTENTION – Les unités peuvent
présenter un risque de basculement lors
de l’installation du kit d’empilage ou lors
du déplacement des unités empilées.
PROCEDURE
1. Position the floor protector near the final
installation location.
2. Uncrate the cabinets. Secure the shelving, doors,
and drawers.
3. Install the anti-tip brackets (see "Anti-Tip Bracket
Installation" on page 45). Verify the brackets are
correctly positioned.
4. Carefully place the upper cabinet on the lower
cabinet.
NOTE: DO NOT LIFT THE CABINET BY THE
COUNTERTOPS, DOORS, DRAWERS, OR GRILLS.
THIS STEP MAY REQUIRE ASSISTANCE.
5. Level the upper cabinet.
6. Align the upper cabinet with the lower cabinet’s
sides and back.
7. Install the rear stacking brackets. See fig. 1.
8. Position the stacked units in the final installation
location.
9. Verify the level of both cabinets. Adjust the leveling
legs as needed. See fig. 2.
10. Remove the upper cabinet’s kickplate. See fig. 3.
11. Install the louver grill. See figs 4-6.
NOTE: Be sure to consider air flow when adding a
panel to the grill or door.
Loading ...
Loading ...
Loading ...