Loading ...
Loading ...
Loading ...
TRUE RESIDENTIAL
®
TEC_TM_156 | REV. D | EN9/12/2022Page 40 of 96
PRIOR TO INSTALLATION
The unit is approved by UL for outdoor installation.
USE OF ADAPTER PLUGS
NEVER USE AN ADAPTER PLUG! An adapter plug alters
the original OEM plug configuration when
connecting it to a power source.
TRUE will not warranty any refrigerator/
freezer that has been connected to an
adapter plug.
USE OF EXTENSION CORDS
NEVER USE AN EXTENSION CORD! An extension cord
is determined to be any component that
adds length to the original OEM power cord
when connecting it to a power source.
TRUE will not warranty any refrigerator/
freezer that has been connected to an extension cord.
• The ice maker should always be plugged into a
dedicated electrical circuit. This provides the best
performance and prevents building wiring circuits
from being overloaded, which could cause a fire
hazard from overheated wires.
• Before your new unit is connected to a power
supply, check the incoming voltage with a
voltmeter. If the recorded voltage is less than the
rated voltage for operation (+/-5%) and amp rating,
correct immediately. Refer to cabinet data plate for
this voltage requirement.
• The electrical outlet must be within 36” (914.4
mm) of the center of the back wall of the ice
maker’s final location. Outlet must be flush with
wall and comply with local electrical codes.
PRIOR TO INSTALLATION
• The wall outlet and circuit should be checked by
a licensed electrician to make sure the outlet is
properly grounded.
• The power cord of this appliance is equipped
with a 3-prong (grounding) plug which mates
with a standard 3-prong (grounding) wall outlet to
minimize the possibility of electric shock hazard
from this appliance. A 115V AC, 60 Hz, 15 amp
circuit breaker and electrical supply are required.
• If the outlet is a standard 2-prong outlet, it is your
personal responsibility and obligation to have it
replaced with the properly grounded wall outlet.
• DO NOT, under any circumstances, cut or remove
the ground prong from the power cord. For
personal safety, this appliance must be properly
grounded.
• When moving the ice maker, for any reason, be
careful not to roll over or damage the power cord.
• Repair or replace immediately all power cords
that have become frayed or otherwise damaged.
DO NOT use a power cord that shows cracks or
abrasion damage along its length or at either end.
• If the supply power cord is damaged, it should be
replaced with original equipment manufacturer
(OEM) components. To avoid hazard this should be
done by a licensed service provider.
• NEVER unplug your ice maker by pulling on the
power cord. Always grip plug firmly and pull
straight out from the outlet.
ELECTRICAL INSTALLATION & SAFETY
Loading ...
Loading ...
Loading ...