Loading ...
Loading ...
Loading ...
13
INSTALLATION INSTRUCTIONS
10 Use duct tape to make all joints secure and air tight.
HD1223
SIDE VIEW
INSIDE BACK OF HOOD
MOTOR / BLOWER
ASSEMBLY
HOLES LOCATION Ø 5 /16 " T Y P.
11 With the hood hanging in place, drill through both holes
located in the inside lower back of hood using a
5
/16" drill
bit. Insert the included drywall anchors into the drilled holes
(one for each hole). Install (2) washers and (2) no. 8 x 1½"
mounting screws through the hood back and into the drywall
anchors. Verify that the hood is centered and leveled. Tighten
all screws completely.
12 Reinstall grease lters by aligning rear lter tabs with slots
in the hood. Pull down the metal latch tab, push lter into
position and release. Make sure lters are securely engaged
after installation.
13 Slightly push aside the upper ue to avoid any damage while
installing the lower ue to the hood top using (2) no. 8 x
3
/8"
screws through the lower ue side slots.
HO0366
UPPER FLUE MOUNTING BRACKET
UPPER
FLUE
14 Slide the upper ue upward until it is aligned with its upper
ue mounting bracket. The bracket should be inside the ue.
Secure the upper ue to the upper ue mounting bracket using
(2) no. 8 x
3
/8" mounting screws.
15 Remove protective plastic lm covering the upper ue and
the hood.
INSTALL THE HOOD
(NON-DUCTED HOODS ONLY)
Non-ducted installation requires a Non-Duct kit for your model
which is separately sold.
AVAILABLE ACCESSORY PARTS NUMBERS
RANGE
HOOD
NON-DUCT
KIT
CHARCOAL
FILTERS
EXTENSION
FLUE
SHC2432FS SKCH32DLK SKCH32CFL
SKCH62EXF
SHC3042FS
SKCH62DLK SKCH62CFLSHC3062FS
SHC3662FS
1
CAUTION
Use only exible duct provided.
2 Do not remove the protective plastic film covering the
decorative ue and the hood at this time.
3 Lay the back side of the hood at on a table. Use a piece of
cardboard to avoid damaging the table or the hood.
4 Attach non-duct collar to non-duct plenum using (4) no.
8 x
3
/8" pan head screws.
5 Measure distance “A”. This will be the length of the extended
ex duct.
A
NON-DUCT PLENUM
6” ALUMINUM
FLEX DUCT
DUCT CONNECTOR
(without flaps)
3-5/8”
NON-DUCT COLLAR
HD1225A
6 Attach aluminum exible duct to the damper / duct connector
with a tie wrap.
7 Attach exible duct to non-duct plenum collar and secure
with tie wrap. Tape all joints with duct tape.
NOTE: 10-ft. ceilings require 10-ft. Flue Extension Model
SKCH62EXF (sold separately). Discard the upper ue supplied
with your hood and replace it with the Model SKCH62EXF
ue extension.
Loading ...
Loading ...
Loading ...