Loading ...
Loading ...
Loading ...
12
INSTALLATION INSTRUCTIONS
10 Plug hood power cord into the outlet.
HD1179
LOWER FLUE MOUNTING BRACKET
LOWER
FLUE
NOTE: 10-ft. ceilings require 10-ft. Flue Extension Model
SKCH62EXF (sold separately). Discard the upper ue supplied
with your hood and replace it with the Model SKCH62EXF
ue extension.
11 Remove the upper ue from inside the lower ue. Install
the lower ue bracket to the lower ue using (2) ue bracket
screws (no. 8 x
3
/8"). Make sure that the bracket is positioned
inside of the lower ue anges - with the slots on top.
Carefully replace the upper ue inside the lower ue. Remove
protective plastic lm covering the lower ue only.
12 Carefully place both ues into the recessed area of hood
top. Slightly push aside the upper ue to avoid any damage
while installing the lower ue to the hood top using (2) no.
8 x
3
/8" screws through the lower ue side slots. Plug hood
power cord into the outlet.
HO0366
UPPER FLUE MOUNTING BRACKET
UPPER
FLUE
13 Slide the upper ue upward until it is aligned with its upper
ue mounting bracket. The bracket should be inside the ue.
Secure the upper ue to the upper ue mounting bracket using
(2) no. 8 x
3
/8" mounting screws.
14 Remove protective plastic lm covering the upper ue and
the hood.
INSTALL THE HOOD (VERTICALLY
DUCTED HOODS ONLY)
1 DO NOT REMOVE the protective plastic lm covering the
decorative ue and the hood at this time.
2 Lay the back side of the hood at on a table. Use a piece of
cardboard to avoid damaging the table or the hood.
3 Remove the grease lters by pulling down the metal latch
tab and tilting lters downward to remove.
4 Carefully rotate hood upright.
HD1179
LOWER FLUE MOUNTING BRACKET
LOWER
FLUE
NOTE: 10-ft. ceilings require 10-ft. Flue Extension Model
SKCH62EXF (sold separately). Discard the upper ue supplied
with your hood and replace it with the Model SKCH62EXF
ue extension.
5 Remove the upper ue from inside the lower ue. Install
the lower ue bracket to the lower ue using (2) ue bracket
screws (no. 8 x
3
/8"). Make sure that the bracket is positioned
inside of the lower ue anges - with the slots on top.
Carefully replace the upper ue inside the lower ue. Remove
protective plastic lm covering the lower ue only.
6 Carefully place both ues into the recessed area of hood top.
DUCT LENGTH
DECORATIVE
FLUE
6” ROUND
STEEL DUCT
HD1251A
7 Measure and install 6" round steel ductwork to the blower
exhaust opening on top of hood. Use metal duct tape to make
all joints secure and air tight.
8 Hold hood up close to wall mounting location and plug power
cord into wall outlet.
9 Align the hood and center it above the hood mounting
bracket. Make sure ductwork on hood lines up and attaches
to ductwork in ceiling. Gently lower the hood until it securely
engages the bracket.
Loading ...
Loading ...
Loading ...