Loading ...
Loading ...
Loading ...
EN
26
Installation
www.bora.com
Securing the cooktop
1
3
2
Abb. 5.28 Mounting brackets
[1] Mounting bracket
[2] Washer
[3] Screw
X
Secure the appliance using the mounting brackets [1].
X
Tighten the mounting brackets with the screw [3] using the
washer [2] with max. 2 Nm.
X
Verify that the alignment is correct.
5.8.2 Installation rotated by 180° (alternative
installation variation)
Installation rotated by 180°
X
Rotate the cooktop 180°.
Abb. 5.29 Rotating the gas elbow tting by 180°
X
Rotate the gas elbow fitting 180° so that the supply can be
connected to the rear.
X
For the installation, proceed as described above.
X
Change the installation direction in the cooktop extractor
configuration menu (see “Configuration menu” in the cooktop
extractor operating instructions).
i
If installation is rotated by 180°, then the ports for the
control knobs and the interface for the cooktop extractor
are at the rear of the cooktops.
i
Cables of sufficient length are provided.
5.9 Establishing communication and
power connection
X
Observe all safety and warning information (see the “Safety”
chapter).
O
The plug for the mains supply cable must be accessible
following installation.
O
If the mains supply cable has been damaged this must be
replaced.
i
The appliance components are linked by the ribbon cable
provided.
5.9.1 Connecting the control knobs
i
Control knobs must only be connected to the ports
provided on the appliance.
1
Abb. 5.30 Back of control knob with port
[1] Port on the back of the control knob
X
Connect the control knobs to the appliances.
Connecting the control knobs to the cooktop
i
In the normal set-up the ports are on the front of the
cooktops.
i
According to the default settings, the left control knob
operates the front cooking zone (zone 1) and the right
control knob operates the rear cooking zone (zone 2).
321
ZONE1 INTERF. COM1 ZONE2
Abb. 5.31 Ports on the cooktop
[1] Front cooking zone control knob port (zone 1)
[2] Extractor electronics interface port
[3] Rear cooking zone control knob port (zone 2)
Loading ...
Loading ...
Loading ...