Loading ...
Loading ...
Loading ...
Care and Cleaning
Proper care and cleaning are
Oven Vent Duct
important so your range-will give
you efficient and satisfactory
service. Follow these directions
carefully in caring for your range to
assure safe and proper maintenance.
Porcelain Enamel
Fin&h
The porcelain enamel finish is
sturdy but breakable if misused,
This finish is acid-resistant.
However.
anv
acid foods
sDi]led
(such as
frui~
juices,
toma~o
or
vine~ar) should not be
Dermitted
To replace cover:
●
Place it into groove of lamp
receptacle. Pull wire bail forward
to center of cover until it snaps into
place. When in place, wire holds
cover firmly. Be certain wire
bail
is
in depression in center of cover.
●
Connect electric power to oven.
Cooktop
Surface Lamp
@ur
range is vented through a duct
WHEN CHANGING A
COOK~P
located
under the right rear Calrod”
LAMP, DO NOT TOUCH THE
unit. Clean the duct often.
METAL AT ENDS OF LAMP.
to
re~ain on the finish:
Your
cooktop
light is easily
LamD
Replacement
replaced with a fluorescent tube
Cleaning Under the Range
The area under the range can be
reached easily for cleaning by
removing the bottom drawer. To
remove, pull drawer out all the way,
tilt up the front and remove it. To
replace, insert glides at back of
drawer beyond stop on range glides.
Lift drawer if necessary to insert
easily. Let front of drawer down,
then push into close.
Removable Oven Door
To REMOVE door, open to BROIL
position, or where you feel hinge
catch slightly. Grasp door at sides;
lift door up and away from hinges.
To REPLACE, grasp door at sides.
Line up door with hinges and push
door firmly into place.
.
.
CAUTION: Before replacing
your oven lamp bulb, disconnect
the electric power for your
Wnge
at the main fuse or circuit
breaker panel.
Be sure to let the
lamp
cover and bulb cool
completely before removing or
replacing them.
The oven lamp (bulb) is covered
with a glass removable cover which
is held in place with a bail-shaped
wire. Remove oven door, if desired,
to reach cover easily.
To remove:
. Hold hand under cover so it
doesn’t fall when released. With
fingers of same hand, firmly push
back wire bail
until
it clears cover.
Lift off cover. DO NOT REMOVE
ANY SCREWS
~
REMOVE
COVER.
●
Replace bulb with 40-watt home
appliance bulb.
of the same wattage. Make sure the
power to the range is disconnected
at main fuse or circuit breaker
panel or plug.
To remove:
●
Lift lamp cover.
●
Place fingers on top near each
end of light bulb.
●
Press down and roll top of bulb
gently toward front until it stops.
●
Remove gently from unit making
sure bulb doesn’t hit lamp cover in
removing.
To replace:
● Place fingers on top near each
end of light bulb.
●
Press
bulb
gently into slots and
roll top of bulb gently toward back
until
it stops.
●
Place lamp cover down.
22
Loading ...
Loading ...
Loading ...