Loading ...
t
TOOLS NEEDED:
Phillips head screwdriver
1 3/8" open end or adjustable wrench
Bracket affaches to floor or wall to hold either right or left
rear leg leveler, if feetening to floor, be sure that screws
do not penetrate electrical wiring or plumbing, if this
cannot be determined, use shorter screws that will not
penetrate through flooring.
if the bracket came with your range, it Is shipped in the
prepack located Inside the oven. Remove the bracket
from the prepacl{ and follow the lnstrucUons below.
1. Decide whether the bracket wi!l be Installed on the
right or left sl_e of range location.
2. if the bracket' side of the range Is adjacent to a
cablnet, place the bracket against back wall and
cabinet as shown In Rgure 1.
if there Is no adjacent cabinet, determine where the
location of the range side (painted outside panel) will
be. Place the bracket with Its outside edge at this
location and against back wail. See Figure 1.
3_
4w
1
Determine whether you will anchor the bracket to th,
floor or wall. Fasten the bracket securely with the
screws provided. Screws are self.drilling In woo(l
plywood, particle and chip board, and most meta
framing. Ifattaching to masonry, youcan buysu|tabl_
screws and anchors at hardware stores. Use
masonry drill to drill the required holes.
Using the wrench, back out the four leg levelers a
least two turns. See your installation guide for mon
leveling Information before positioning range.
Slide the range Into place. Be sure rear leg levele
fully engages slot in bracket, if range cannot ba
moved back far enough for rear leg leveler to eats
bracket, move bracket forward as required and attacl
to floor in new location.
ADJACENT CABINET OR RNAL
LOCATION OF RANGE SIDE
PANEl,,
OUTSIDE EDGE OF
BRACKET TO BE
FLUSH WITH LEFT OR
RIGHT SIDE OF RANGE
-\
WALL BI_HtND
RANGE
BRACKET
SCREW MUST ENTER
WOOD OR METAL
--.....
WALL
PLATE
/
ATTACHMENT TO WALL
Ftg. 1
Fig. 2
1 NCINS01-_
Loading ...
Loading ...
Loading ...