Loading ...
Loading ...
Loading ...
Operation
28
Open the drawer and the glass lid.
a
b
c
O
P
E
N
Place the vacuum adapter over the
vacuum pump air intake valve.
Attach the connector to the con-
tainer lid. Make sure that the closure
of the lid is turned to “SEAL” (closed).
Switch the drawer on with the On/
Off sensor control.
The segment bar indicator lights above
the and sensor controls light up.
Touch the sensor control.
The segment bar indicator lights above
the and sensor controls go out.
The segment bar indicator lights above
the and sensor controls light up.
Touch the sensor control re-
peatedly until the segment bar indic-
ator light for the required vacuum set-
ting lights up.
Touch the sensor control.
The vacuum sealing process will start.
The sensor control goes out and
the sensor control lights up.
Leave the glass lid of the drawer open
for the entire duration of the vacuum
sealing process.
If an excessive amount of bubbles
form, you can cancel the vacuuming
process by pressing the sensor
control (see “Operation – Cancelling
the vacuum sealing process”).
Loading ...
Loading ...
Loading ...