Loading ...
Loading ...
Loading ...
Operation
24
After the vacuuming process
A signal sounds.
Open the glass lid.
Danger of burning due to hot
surfaces.
The sealing bar and weld seam are
hot.
Do not touch the sealing bar or the
weld seam immediately after the va-
cuuming process.
Remove the vacuum sealing bag from
the vacuum chamber.
Before starting a new vacuuming
process, check that the vacuum
chamber and the sealing bar are
clean and dry.
Remove any soiling or liquid residues
if necessary.
Sealing the bag early
You can end the vacuuming process
before reaching the selected vacuum
settings and seal the bag early.
Touch the sensor control.
The vacuuming process stops. After a
few seconds the bag will be sealed.
Successful sealing of the bag is only
possible when there is a minimum va-
cuum (vacuum setting 1) in the cham-
ber.
Touch the sensor control again if
the required vacuum setting has not
yet been reached. For technical reas-
ons, a few seconds will elapse before
the bag is sealed.
Loading ...
Loading ...
Loading ...