Loading ...
Loading ...
Loading ...
POWER
SPEAKERS
%
On the amplifier's display
BAND
%
DIRECTTUNING
,:,:,:,
f I I I
I 7 I 8 1 9 It o I Lightsup when tuned
b I
Lights up when an FM stereo broadcast is received
I Direct tuning 1
Specify the frequency using the numeric buttons to directly tune to
the desired broadcast station.
H Press POWER of the amplifier and tuner.
First switch on the power of the amplifier.
The units will switch on.
At power ON, if the "TAPE MONITOR" indicator I
flashes on the amplifier's display ..........
I
Press TAPE MONITOR and check the indicator goes out.
Press SPEAKERS to turn on the speaker systems.
[] Press TUNER.
U Press BAND to select "FM" or "AM".
B Press DIRECT TUNING.
El
(While cursor display is flashing [approx. 10 seconds])
Press the appropriate numeric buttons to enter the
frequency.
If the desired FM frequency is 107.9 MHz
[_--@--,[_--,[]
If the frequency has been input correctly, the frequency
display will blink.
1. If no button is pressed while the cursor display is flashing,
the display will return to the frequency which is currently
being received. To re-specify the frequency, repeat the
procedure from step 5.
2. If the frequency has not been input correctly, the frequency
display will blink rapidly. In this case, re-enter the
frequency.
_--_ Turn VOLUME to adjust the volume level.
°________°..______°°°*oo______._°__°._._.°__°.°_.__.__..._.._....____.......°__°_
If noise is excessive in the FM stereo mode
Press FM MODE. (The "STEREO" indication will go out, and
"MONO" indication will light up.).
The broadcast will be monaural, but noise will be reduced. If the
button is pressed oncemore, stereo mode will be resumed.
While set to monaural, whenever you change the frequency or
change the input source and turn the unit OFF/ON, the monaural
mode is automatically canceled.
After listening is finisbed
Be sure to reduce the volume level, and switch the power to the
standby condition by pressing POWER of the arnpi_er_-
The power for the system can thereafter be switched on and to the
standby condition by using the power switch of the amplifier.
(provided that the power cords are connected as on page 6.)
O)
m
Loading ...
Loading ...
Loading ...