Loading ...
Loading ...
Loading ...
61
Refrigerant Piping Connections
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. “LG” is a registered trademark of LG Corp.
REFRIGERANT PIPING CONNECTIONS
Remote Controller
Installing Batteries into Remote
Controller
As part of test running, you will need to insert batteries and power on
the remote controller. To insert the batteries follow the steps below. For
information on using the remote controller, refer to its owner’s manual.
Procedure
1. The remote controller needs two AAA (1.5V) batteries for operation.
Remove the battery cover from the back of the remote controller
(Figure 76).
• Push downward on the tab at the top of the battery cover and then
lift up to remove.
2. Insert the two new batteries.
• Align batteries by the (+) and (-) sides.
• The interior battery compartment of the remote controller will have
clear markings for the (+) and (-) placement.
3. Verify that the batteries have “clicked” into the compartment and
are firmly engaged with the contacts on either side of them.
4. Reattached the back cover of the remote controller.
5. Proceed with powering on the remote controller and usage as
needed.
1. Push down on tab
2. Lift cover
3. Insert 3
batteries
Single Zone Remote Controller - Rear View
Battery Cover
Ta b
Battery
Cover
Figure 76: Remote Controller - Installing Batteries
Loading ...
Loading ...
Loading ...