Loading ...
Loading ...
Loading ...
22PLUS REAR WHEEL DRIVE MODELS: "ENGINE
1, Remove screws securing rear baffle,
2,, Turn lawn mower on its side with air
filler and carburetor down.,
3., Remove rear baffle from mower,
4., Remove blade bolt, lockwasher, hard-
ened washer and blade_
5o Remove debris shield,
6o Remove gearcase belt keeper,
7., Remove drive belt.
Rear
Gearcase
belt keeper
Bel!
retainer
Blade
bolt
CARBURETOR
The carburetor has been preset at the fac-
tory and adjustment should not be neces-
sary, However, minor adjustment may be
required to compensate for differences In
fuel, temperature, altitude or load,
. The air filter must be assembled to the
carburetor when running engine,,
. Best carburetor adjustment is obtained
when fuel tank is 1/4 full.,
. In order for the engine to run, the opera-
tor presence control bar must be held
in the operating position. Therefore,
and assistant will be required to hold
the control bar in the operating position
when making final adjustment to the
carburetor.
See the ADJUSTMENT section of your
engine manual for further instructions.
ENGINE SPEED
The engine speed has been factory set,
Do not attempt to increase engine speed
as it may result inpersonal injury. If you
believe the engine is running too fast
or too slow, take your lawn mower to an
authorized engine service center for repair
and adjustment,,
THROTTLE CONTROL
Ifit becomes necessary toadjustor re-
place the throttlecontrol, see the ADJUST-
MENT section of your engine manual,
TO REPLACE DRIVE BELT
1o Place new drive belt on gearcase pul-
ley,,
NOTE: Always use factory approved bel!
to assure proper fit and long life_
2, Reinstall gearcase belt keeper. Be
sure the new drive belt is inside the
tabs of the gearcase belt keeper.
3, Position the blade adapter on the en-
gine crankshaft. Be sure key in adapter
and crankshaft keyway are aligned;
and that the drive belt is inside the tabs
of the belt retainer,
4_, Place rear baffle in mower housing,
5o Reinstall debris shield,
6. Reinstall blade.
7_ Return mower to upright position
8., Reinstall rear baffle screws. 32
Loading ...
Loading ...
Loading ...