Loading ...
Loading ...
Loading ...
ALIGNMENTS AND ADJUSTMENT, Continued
Hot Oven Restart
if you turn off the oven but then decide to turn it back on before it has cooled to room
temperature, the burner may not light properly 'l'his is due to the thermostat still sensing
a heated oven and not allowing the maximmn gas flow rate into the burner Press in and
turn the oven control knob counter clockwise all the way to the ' BROIL" position to
relight the burner. After the burner has ignited, you may adjust the oven control to the
desired temperature
if tile oven burner does not ignite and maintain the flame, one of the following situations
may have occurred
1 The pilot burner has _one out. Relight the oven pilot
2 The pilot will not keep the flalne safe_" probe heated. Adjust the size of the pilot
flame Or, tile thermocouple connection at tile thermostat may need to be tightened
3 The flame safety probe nlay not be properly located. Locate the probe directly
over the pilot burner On spark ignition ovens, tile end of tile flame safety probe
must ve15" close to tile side of tile burner right in front of tile flame ports
4 The burner is not ill its proper position. Make sure the rear of tile burner is seated
on the iNector elbo_x and tile front is bolted onto the burner support
5 The spark i_.,mitor is defective. Contact an authorized service technician
6 The ghm bar ignitor is defective. Contact an authorized service technician
6. Oven Burner Air Shutter Adjustlnent
i'he oven burner flame should be a clean, blue flame with distinct inner cones
approximately " long A soil, lazy flame with indistinct cones means too much gas or
not enough air. A noisy lilting flame means too much air if adjustments are necessary
you must first loosen tile lock screw located at tile top of tile air shutter, then rotate the air
shutter to correct setting, and retighten screw
OVEN BURNER
LOCK SCREW
AIR SHUTTER
ORIFICE_
OVEN SAFETY VALVE OVEN BURNER
Oven burner flame can be checked as follows (xxithout burner baflle in place):
• fo correct a yellow flame-increase size of air shutter opening.
• fo correct a lifting, but distinct, blue flame-Decrease size of air shutter opening
fhe air shutter should be set approximately 2/3 open for natural gas, and approximately
l\fll open on LP (Propane) gas
19
Loading ...
Loading ...
Loading ...