Loading ...
Loading ...
Loading ...
ToAdd, Reprogramor Changea Keyless EntryPIN
NOTE:Your new KeylessEntry must be programmed to operateyour garagedoor opener.
USINGTHE"LEARN"BUTTON USINGTHEDOORCONTROL
oo o_
1. Press and releasethe "learn" button
on motor unit. The learn indicator light
will glow steadily for 30 seconds.
2. Within 30 seconds, enter a four digit
personal identification number (PIN) of
your choice on the keypad.Then press
and hold the ENTERbutton.
3. Releasethe button when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks
will be heard.
To change an existing, known PIN
If the existing PIN is known, it may be changed by one person
without using a ladder.
1. Press the four buttons for the present PIN, then press and hold
the # button.
The opener light will blink twice. Releasethe # button.
2. Press the new 4-digit PINyou have chosen, then press ENTER.
The motor unit lights will blink once when the PIN has been
learned.
Test by pressing the new PIN, then press ENTER.The door should
move.
Toset a temporaryPIN
You may authorize accessby visitors or service peoplewith a
temporary 4-digit PIN. After a programmed number of hours or
number of accesses,this temporary PIN expires and will no longer
open the door. It can be used to closethe door even after it has
expired. To set a temporary PIN:
1. Press the four buttons for your personal entry PIN
(not the last temporary PIN), then press and hold the _,,button.
The opener light will blink three times. Releasethe button.
NOTE:This method requires two people if the KeylessEntry is
already mounted outside the garage.
1. Enter a four digit personal identification
number (PIN) of your choice on the
keypad. Then press and hold ENTER.
,
,
,
While holding the ENTERbutton, press
and hold the LIGHTbutton on the Motion
Detecting Control Console.
Continue holding the ENTERand LIGHT
buttons while you press the push bar on
the Motion Detecting Control Console
(all three buttons are held).
Releasebuttons when the motor unit lights
blink. It has learned the code. If light bulbs
are not installed, two clicks will be heard.
\J /
2. Press the temporary 4-digit PINyou havechosen, then press
ENTER.
The opener light will blink four times.
3. To setthe number of floursthis temporary PIN will work, press
the number of hours (up to 255), then press _--.
OR
3. To setthe number of timesthis temporary PIN will work, press
the number of times (up to 255), then press #.
The opener light will blink once when the temporary PIN has been
learned.
Test by pressing the four buttons for the temporary PIN, then
press ENTER.The door should move. If the temporary PIN was set
to a certain number of openings, remember that the test has used
up one opening. To clear the temporary password, repeatsteps
1-3, setting the number of hours or times to 0 in step 3.
One ButtonClose: Openercan beclosed by pressing only the ENTERbutton if the one button closefeature has beenactivated. This
feature has beenactivated at the factory. To activate or deactivate this feature press and hold buttons 1 and 9 for 10 seconds. The
keypadwill blink twice when the one button close is active. The keypadwill blink four times when one button close is deactivated.
36
Loading ...
Loading ...
Loading ...