Loading ...
Loading ...
Loading ...
INSTALLINGTHEBRACKETS
Be surepower to the opener is disconnected.Install and align
the brackets so the sensors will face each other across the garage
door, with the beam no higher than 6" (15 cm) abovethe floor.
They may be installed in one of three ways, as follows.
Garagedoor track installation (preferred):
1. Slip the curved arms over the rounded edge of each door track,
with the curved arms facing the door. Snap into place against
the side of the track. It should lie flush, with the lip hugging the
back edge of the track, as shown in Figure 1.
If your door track will not support the bracket securely, wall
installation is recommended.
Wall installation (Figures 2 & 3):
1. Placethe bracket against the wall with curved arms facing the
door. Be sure there is enough clearancefor the sensor beamto
be unobstructed.
2. If additional depth is needed,an extension bracket
(see Accessories) or wood blocks can be used.
3. Use bracket mounting holes as a template to locate and drill (2)
3/16" diameter pilot holes on the wall at each side of the door,
no higher than 6" (15 cm) above the floor.
4. Attach bracketsto wall with lag screws (not provided).
5. If using extension bracketsor wood blocks, adjust right and
left assembliesto the same distance out from the mounting
surface. Make sure all door hardware obstructions are cleared.
Floor installation (Figure 4):
1. Usewood blocks or extension brackets (seeAccessories) to
elevatesensor brackets so the lenses will be no higher than
6" (15 cm) abovethe floor.
2. Carefully measureand place right and left assembliesat the
same distance out from the wall. Besure all door hardware
obstructions are cleared.
3. Fastento the floor with concrete anchors as shown.
Figure1
i Door
l/I TraC p
_ seneo_r_
acket
Figure2
DOOR TRACKMOUNT (RIGHT SIDE)
WALLMOUNT (RIGHT SIDE)
Indicator
Light
Fasten Wood Block to Wall with
(Not Provided)
Indicator
Light Sensor
Bracket
(Not Provided)
Lens
Figure 3 WALL MOUNT (RIGHT SIDE)
Extension
Bracket
(See Accessories)
(Provided with
Extension Bracket)
Carriage Bolt
1/4"-20xl/2"
HARDWARESHOWN ACTUALSIZE
Wing Nut
1/4"-20
Insulated Staples
(Not Shown)
Figure4
(Provided with
Extension
Bracket) _J
Sensor
Bracket
Indicator
Lens Light
FLOORMOUNT (RIGHT SIDE)
¢i-- ttach with
Concrete Anchors
; (Not Provided)
J
Indicator
Light
Bracket
21
Loading ...
Loading ...
Loading ...