Loading ...
Loading ...
Loading ...
38
Appendix
TipsSettingsPlayback
Contents
Front panel Display Rear panel IndexRemote
Connections
%
•When using this unit, we recommend you use a router equipped with the following
functions:
•Built-in DHCP server
This function automatically assigns IP addresses on the LAN.
•Built-in 100BASE-TX switch
When connecting multiple devices, we recommend a switching hub with a speed
of 100 Mbps or greater.
•Use only a shielded STP or ScTP LAN cable which is easily available at electronics
stores (CAT-5 or greater recommended).
•The normal shielded-type LAN cable is recommended. If a flat-type cable or
unshielded-type cable is used, other devices could be aected by noise.
NOTE
•The types of routers that can be used depend on the ISP. Contact your ISP or a
computer shop for details.
•This unit is not compatible with PPPoE. A PPPoE-compatible router is required if
you have a contract for a type of line set by PPPoE.
•Do not connect an NETWORK connector directly to the LAN port/ Ethernet
connector on your computer.
Connecting an external control
device
REMOTE CONTROL jacks
If this unit is installed in a location that is out of range of the signal from
the remote control unit (such as when installed in a cabinet), you can still
operate the unit and the devices connected to it by using a commercially
available IR receiver.
You can also use it to remotely control ZONE2 (another room).
FRONT FRONT
CENTER SURROUNDSURROUND
AUX
OUT
Infrared
retransmitter
Infrared
sensor
Output
Input
Loading ...
Loading ...
Loading ...