Loading ...
Loading ...
Loading ...
31
CONTROL PANEL REMOVAL
1. Turn the control knob(s) to the OFF position and turn off the gas
supply to the unit.
2. Turn off the light switch and disconnect the power supply from the
power source.
3. Pull the control knob(s) from the stems and set aside.
4. Slowly lift the lighted bezels to clear the valve stems, and let rest as
shown in Fig. 31-1.
5. Pull the lighting instruction plate outward (Black Diamond models only).
6. Using a Phillips screwdriver, unscrew and remove the control panel
fastener screws and washers (located on the left and right front face of the control panel). Retain
the screws for later re-installation.
7. Carefully open the control panel by lifting and pulling the control panel from the frame.
Important: When opening, take caution to not damage any wiring.
8. If wire disconnections are required, reference the wire diagram in the MODEL SPECIFICATIONS
section in this instruction manual or the wire diagram label affixed to the inside of the control panel.
Note: Secure any disconnected wires (coming from the inside of the unit) to prevent them from falling in.
Note: Whenever reconnecting any wires, apply a small amount of dielectric grease to the male connector,
then make the connection. This will ensure conductivity and prevent moisture from affecting the
contact.
Important: To ensure the interior oven lights function: when reinstalling the control panel, set it
back over the front lip of the grill so that the light micro switch activation pin protrudes
through the hole on the upper right of the control panel (if applicable). See Fig. 31-2.
Important: During reinstallation; prior to opening the gas shut-off valve, be sure the control knob(s)
are in the OFF position.
Fig. 31-1
Bezel
removed
SERVICING AND CLEANING (Cont.)
Loading ...
Loading ...
Loading ...