Loading ...
Loading ...
Loading ...
23
TO INSTALL USING AN INDEPENDENT POWER SUPPLY BOX (NOT INCLUDED):
1. Locate the "Y" end of the wire harness extension that is included with the sideburner and connect the
compatible end to the power supply connectors (see Fig. 23-1, A).
2. Connect the opposite end of the wire harness extension to the sideburner connectors (see Fig. 23-1, B).
For multiple side cooker connections to one independent power supply, reference the previous pages to
assist with connections. (Omit the grill wire harness connection.)
INSTALLATION (cont.)
POWER SUPPLY INSTALLATION
CAUTION: IMPROPERLY CONNECTED WIRES WILL CAUSE DAMAGE TO THE GRILL AND/
OR SIDEBURNER AND MAY RESULT IN PROPERTY DAMAGE AND/OR PERSONAL
INJURY.
To install the power supply box:
1. It MUST be located at least 12 inches below the bottom of the grill and/or sideburner (see Fig. 23-2).
2. The wire extension that exits from the control panel MUST be routed directly downward. This will prevent
overheating. DO NOT route the wire extension below the grill and/or sideburner (see Fig. 23-2).
Note: For enclosures with a solid area beneath the grill and/or sideburner, a cutout must me made near the wire
extension to allow for the above requirement. If an insulating liner is installed with the grill, route the wire
down through the nearest hole possible.
3. Mount the power supply box to the inside of the enclosure using appropriate hardware for your enclosure.
WARNING: DO NOT block the vent holes found on the box.
4. Connect the cord coming from the power supply to a 120VAC (15 AMP minimum) GFCI GROUNDED
3-wire receptacle (see Fig. 23-2). The GFCI receptacle must be a WEATHER-PROOF IN-USE COVERED
RECEPTACLE.
WARNING: Electrical Grounding Instructions - This appliance is equipped with a three-pronged (grounding)
plug for your protection against shock hazard and should be plugged directly into a properly
grounded three-prong receptacle. Do not cut or remove the grounding prong from this plug.
Fig. 23-2
12"
Min.
1. Locate power supply box
2. Route wire harness extension(s)
downward
3. Mount power supply box
4. Connect cord to power source
120VAC
(15 AMP minimum)
GFCI GROUNDED
3-wire receptacle
Route wires
directly
downward
(to prevent
overheating)
Power supply
Wire harness extension
(included with sideburner)
DO NOT
DISCONNECT
Fig. 23-1
A
Connect
B
Connect
Take note of labels
on harnesses when
connecting.
EXT.
POWER
SUPPLY
1
2
3
Loading ...
Loading ...
Loading ...