Loading ...
Loading ...
Loading ...
19
It is not required to remove the control panel or knobs to
install this unit.
DO NOT lift the unit from the control panel when installing.
COUNTER PREPARATION
Consult Table 3 for enclosure cut-out dimensions. If the
counter or any supporting construction is combustible, the
COMBUSTIBLE ENCLOSURE CUTOUT section must be
followed before beginning the installation.
This sideburner must be supported by the stainless-steel
hanger extending from the upper portion of the frame. The
hanger rests on the left, right, and back of the countertop.
The control panel is designed to sit flush against the enclosure
front wall (see Fig. 19-1). If the enclosure countertop extends
beyond the front wall, creating a countertop overhang (see Fig.
19-2), it must be cut flush with the front wall for the width of
the control panel or a gap will be created exposing the forward
portions of the left and right side fire walls of the unit. See the
MODEL SPECIFICATIONS section.
CONNECT THE GAS SUPPLY
For propane cylinders:
For connecting a propane unit to a portable propane tank,
read the safety warnings and follow the instructions in the
section SAFE USE AND MAINTENANCE OF PROPANE GAS
CYLINDERS.
Note: When a propane cylinder is installed inside of the
enclosure, the guidelines found in the ENCLOSURE
/ VENTILATION REQUIREMENTS section MUST
be followed.
For household propane or natural gas units:
CAUTION: Use only C.S.A. listed stainless-steel flex
connectors within the enclosure.
WARNING
A rubber or plastic connector will rupture or leak, resulting
in an explosion or serious injury if used inside the
appliance enclosure.
1. Locate the attached flex connector (found underneath the
unit) and route it to the gas supply stub.
2. Turn OFF the gas supply at the source.
3. A shut-off valve is required within 6 feet of the unit.
If shut-off valve is installed in-line:
• Install the supplied flare-to-NPT adapter to the gas
supply (NPT) using a pipe joint compound resistant to
all gasses (see Fig. 19-3, A). Tighten securely.
• Connect the flex connector to the flare-to-NPT adapter
(see Fig. 19-3, A). Tighten securely.
If shut-off valve is connected to end of gas supply stub:
• Connect the flex connector to the shut-off valve (flare)
(see Fig. 19-3, B). Tighten securely.
INSTALLATION
INSTALLATION
Fig. 19-4 Household LP & natural gas diagram
(Countertop)
GAP CREATED
Proposed cut-out
in overhang
Control panel
stops here
INCORRECT
Fig. 19-2 Countertop overhang - incorrect cutout
(Double sideburner
shown)
IDEAL
Flush-mounted
control panel
Overhang
Fig. 19-1 Countertop overhang - correct cutout
CORRECT
(Countertop)
Hanger
Flex
connector
Flare-to-NPT
adapter
Gas supply (NPT)
OFF
Gas supply
Shut-off valve (shown
in-line) must be within 6
feet of the unit
Cutout
Fig. 19-3 Connecting to a gas line
Gas supply
(NPT)
Flex
connector
(from unit)
Flare-to-NPT
shut-off valve*
(end of
gas supply)
NPT-to-NPT
shut-off valve*
(in-line)
Gas supply
(NPT)
Flare-to-NPT
adapter
Flex
connector
(from unit)
* Shut-off valve: required, not included, must
be within 6 feet of unit
A B
-OR-
Loading ...
Loading ...
Loading ...