Loading ...
Loading ...
Loading ...
,
Remove the door(s) (see "Step 4: Door Removal and
Reinstallation" on page 10). This will create an
estimated reduction in the weight as shown in "Chart A"
and allow the range to pass through 30" (762mm)
doorways (see clearances shown on page 6).
_ 36" 48"
chart A Range Range
,
420 Ibs 590 Ibs
Shipping Weight
(191 kg) (268 kg)
Weight without packing 360 Ibs 530 Ibs
materials (163 kg) (240 kg)
Without door(s), burner caps, 260 Ibs 390 Ibs
and oven racks (118 kg) (177 kg)
CAUTION:
DO NOT lift the range by the oven door's handle, as this
may damage the door hinges and cause the door to fit
incorrectly.
All ranges are held to the pallet by (4) bolts through a
wood block center (Figure 6). The two front pallet bolts
are accessible only after removing the Door Trim
located beneath the doors.
• The Door Trim is removed by loosening the 2
screws attaching it to the range and sliding it up
and off the screws.
4. After removing the pallet bolts using (2) 1/2" (13mm)
wrenches (one to hold bolt at the bottom while the
other is loosening the nut at the top) and discarding the
wood packing block inserts, the range may be carefully
tilted back on the (2) casters (see Figure 22 on
page 22) and removed from the pallet. Use additional
help as required to remove from pallet.
• Due to the weight, a furniture dolly with soft wheels
or an air lift should be used to move this unit. The
weight must be supported uniformly across the
bottom (see Figure 7).
5. After transporting the range by dolly close to its final
location, the range can be tipped back and supported
on the rear casters while the dolly is carefully removed.
• Complete "Step 5: Installing Anti-Tip Device", "Step
6: Gas Requirements and Hookup", "Step 7:
Electrical Requirements, Connection & Grounding",
and "Step 8: Backguard Installation (optional)"
before the range is placed in its final position.
• Use the casters to assist with the installation near
to its final location. THE FLOOR UNDER THE
LEGS SHOULD BE PROTECTED BEFORE
PUSHING THE UNIT INTO POSITION.
Range must be
uniformly
supported
by braces
provided
on bottom
of range
Packing Blocks
Pallet Bolts _ ._
FIGURE 6: DOOR TRIM, PACKING BLOCKS, & PALLET BOLTS
FIGURE7: FURNITURE DOLLY POSITIONING
English 9
Loading ...
Loading ...
Loading ...