Loading ...
Loading ...
Loading ...
Reformer Owner’s Manual
Replacement Parts
FOOTBAR
With
1
⁄4” hex key, fasten footbar to the
large swing arm bars with socket head cap
screws. With footbar in place, apply pressure
to footbar before tightening socket head
cap screws. Tighten completely only when
both sides of footbar are attached to ensure
proper alignment.
NOTE: Socket head cap screws are attached
to the ends of the replacement footbar when
it is shipped.
PULLEY BLOCK FIXED & TRAVELING
w
Unscrew threaded bolt [57] that passes
through end shaft of pulley block and
the left and right arms of the swivel
harness [58].
w
Remove swivel harness from eyehook
[54], and remove pulley block and
replace with new pulley block.
w Pass swivel harness through eyehook.
w
Pass bolt through right side of swivel
harness and the center of the end shaft
of pulley block.
w
Screw bolt through left side of
swivel harness.
FIXED ROLLERS
Attach fixed rollers with the aid of a
ratchet and
1
⁄2” socket attachment.
CAUTION: Never use oil lubricants
as they may damage rollers.
FLOATING ROLLERS
With carriage removed from aluminum
rails, (see page 18) slide floating rollers into
bronze bushings. Replace carriage
(see page 24).
CAUTION: Never use oil lubricants as they
may damage rollers.
SPRING CLIPS
Replace spring clips every 12 months or
earlier as needed.
CAUTION: Locking spring clips must be
used to attach push-thru springs to the
vertical frame from below. Do not use
non-locking spring clips.
PADDED SHOULDER RESTS
NOTE: Only shoulder rest pads are shipped
for replacement. Loosen bolts on handle
frames, remove worn pads, replace with
new and tighten bolts.
CARRIAGE STOPPER
NOTE: Only one is needed per Reformer.
Must be in one of the six positions
AT ALL TIMES.
SAFETY CHAIN
For use with push-thru bar.
57
58
Floating Roller
Bronze Bushing
REFORMER ROPES
RETRACTABLE ROPE SYSTEM: See page 22
for installation.
54
26
Loading ...
Loading ...
Loading ...