Loading ...
Loading ...
Loading ...
merrithew.com
19
Replacing Springs
3 Using second
7
⁄16" wrench on opposite side, loosen nylon
locknut. This may require a bit of force.
NOTE: Discard used nylon locknuts. New ones are
provided with new springs.
5 Repeat steps 2 to 4 on remaining springs.
4 Remove spring bolt from spring anchoring bar, then
pull ball end of the spring out of spring holding loop.
2 With
7
⁄16" wrench or pliers, hold fixed cube nut in place.1 Remove carriage, see page 18 for full instructions.
REQUIRED TOOLS:
pliers or two wrench
1
/
2
"(13mm) x
7
/
16
"(14mm)
Spring Ball
Spring SleevesSpring Coils Fixed Cube Nut
Bolt End
of Spring
Spring Bolt
Nylon Locknut
Ball End of Spring
IMPORTANT: Werecommend thatyou replace thesprings
on your reformer every two years to ensure maximum
performance and safety of your reformer at all times.
Loading ...
Loading ...
Loading ...