Loading ...
Loading ...
Loading ...
B@TH M@@ELS
BACKUP BEARING
6 lnslall the special non-metallic blade guides supplied
wilh the 1!16-inch blade as shown. Separate these
guides as far as they will go
NON-METALLIC l NON-METALLIC
BLADE GUIDE BLADE GUIDE
SEPERATE GUIDES
AS FAR AS POSSIBLE
7 Uncoi! the 1/i 6-inch blade and place over the wheels
with the teeth facing front of saw and pointing down
towards the table,
WARNING: To avoid serious eye Injury or ]
scrapes if the blade should suddenly uncoil, _I
wear safety goggles. Carefully uncoil the blade
1
holding tt at arms length.
NOTE: If the blade will not reach arour:d both wheels,
lower the upper wheel by turning the blade tension
knob counte[clockwise to the "0" position.
8 Turn the tension knob clockwise to adjust tension to
the sanding position (the letter"S"), This isthe correct
tension for the 1/16-inch blade.
TURN TO
"O" POSITION
\
BLADE TENSION KNOB
9 Turn the upperwheel by hand afewtimes andtumthe
l_acking adjustment screw to keep the 1t16-inch
blade running in the center of the upper wheel,
TRACKING ADJUSTMENT SCREW
t
34
Loading ...
Loading ...
Loading ...