Loading ...
Loading ...
Loading ...
Frequently Asked Questions
71
Problem Possible cause and solution
Empty the drip tray and the
waste container appears
in the display, even
though the drip tray is
empty.
The drip tray is not positioned correctly in the appli-
ance.
Push the drip tray in as far as it will go.
Make sure that the lower panel is sitting on the
drip tray correctly.
Insert the drip tray and the
waste container appears
in the display even
though both are fitted.
The drip tray is not correctly fitted and is therefore not
detected.
Empty the drip tray and the grounds container. Re-
assemble all parts and place the drip tray and the
grounds container back in the coffee system.
The service is open.
Close the service door.
If necessary, empty the drip tray and the grounds
container. Reassemble all parts and place the drip
tray and the grounds container back in the coffee
system.
The drip tray or the
grounds container is
too full or runs over al-
though the drip tray and
the grounds container
were emptied after
each message on the
display.
This is not a fault.
The drip tray and grounds container were probably re-
moved or the appliance was opened without the drip
tray and grounds container being emptied. When the
drip tray is removed or the appliance opened, the in-
ternal counter for emptying the drip tray and grounds
container is automatically reset.
Remove the drip tray and grounds container from
the appliance and empty them.
Fill the bean containerap-
pears in the display
even though the bean
container has just been
filled.
This is not a fault.
Confirm the message with OK.
The coffee system does
not rinse itself when
turned on.
This is not a fault.
If the coffee system still has an operating tempera-
ture higher than 140°F (60°C), rinsing will not take
place.
Loading ...
Loading ...
Loading ...