Loading ...
Loading ...
Loading ...
En
34
Click the [ASIO] tab.
! If the buffer size is made large, drops in audio data (breaks in the
sound) occur less easily, but the time lag due to the delay in the
transfer of the audio data (latency) increases.
Changing to the desired effect type
The effects set to the [BEAT FX] and [FILTER] controls on the unit can
be changed to the desired effects on the [FX BANK] tab. For details, see
Using the FX BANK function (p. 24 ).
Changing the settings
The following settings can be changed on the [PREFERENCE] tab.
!
[4BEAT LOOP] button function
If a check mark is placed in the check box, the [4BEAT LOOP] button
on the unit functions as the [AUTO BEAT LOOP] button.
! Pad mode button operation
If a check mark is placed in the check box, the “two presses function”
and “three presses function” for the performance pads are enabled
when the pad mode is switched.
— If two computers are connected to this unit and separate com-
puters are selected by the [INPUT SELECT] switches of [CH1] and
[CH2], the functions are enabled only when the setting on each
computer is on.
!
Fader start function
If a check mark is placed in the check box, the fader start function is
enabled. For details on the fader start function, see Using the fader
start function (p. 19 ).
! Adjustment of the ranges that do not output sound on both edges of
the crossfader.
The ranges that do not output sound on both edges of the crossfader
can be adjusted by moving the slider.
— This setting is disabled and the default setting is applied when
two computers are connected to this unit and [CD/LINE] or
[PHONO] is selected by the [INPUT SELECT] switches of [CH1]
and [CH2].
! Prevention of a drastic change in volume that occurs when the
crossfader is operated
In case that the volume level drastically changes due to the opera-
tions of the crossfader, the volume can be set to the moderate level
by adjusting the time it takes for volume change.
— [NONE] is set when two computers are connected to this unit
and the [INPUT SELECT] switches are set as follows.
! Separate computers are selected by the [INPUT SELECT]
switches of [CH1] and [CH2].
! [CD/LINE] or [PHONO] is selected by the [INPUT SELECT]
switches of [CH1] and [CH2].
Checking the version of the firmware and
driver software
Display the setting utility before starting.
Click the [About] tab.
Checking the latest information on the
driver software
For the latest information on the driver software for exclusive use with
this unit, visit our website shown below.
http://pioneerdj.com/support/
! Operation cannot be guaranteed when multiple units of this mixer
are connected to a single computer.
Loading ...
Loading ...