Loading ...
Loading ...
Loading ...
En
25
Using the DVS system
Using the DVS system
This unit allows you to use the Serato DJ software and control disc
1
to operate digital music files using familiar analog players or DJ players.
1 A special CD and record containing the signals necessary for operating digital music files.
Before controlling the Serato DJ software
About input channels
1
2
1
2
4
4
33
5
The signals played on the Serato DJ software’s decks [DECK1] to
[DECK4] are input to this unit’s respective channels.
The combinations of the decks and the respective channels to which the
sound is input are fixed. These combinations are shown below.
Correspondence table of Serato DJ software decks and
DJM-S9 channels
Serato DJ software deck
DECK1 DECK2 DECK3 DECK4
DJM-S9 channel
CH1 CH2 CH1 CH2
Set the positions of the controls, etc., as shown below.
Names of controls, etc. Position
INPUT SELECT switch USB-A or USB-B
Names of controls, etc. Position
TRIM control Turned fully counterclockwise
ISO (HI, MID, LOW) controls Center
Serato DJ setting screen
Computer screen when the Serato DJ software and this
unit are connected (setup screen)
This is the Setup screen displayed when the computer and this unit are
connected after installing the driver software.
1
12
1 CALIBRATION DECK
The Serato DJ software calculates analog signals from the control
disc and processes the signals of digital audio files.
Different signal levels and device statuses can be calculated for each
usage environment to make the optimum settings for reading out the
control signals.
! When CALIBRATION DECK is not displayed, click the
[Expansion Packs] tab. Then, from the list, select [Vinyl/CDJ
Control] and tick the [Enable Vinyl/CDJ control] check box.
2 Utility settings
Utility settings such as settings affecting the entire system and
detailed operation settings can be made here.
Loading ...
Loading ...
Loading ...