Loading ...
Loading ...
Loading ...
• Secure the panel to the trim temporarily by driving
2 screws through the back side of the trim at the top.
• Slide door extrusion in between panel and steel door.
Temporarily secure with 2 screws.
• Drill 1⁄16" pilot hole through the panel until it starts
into the aluminum extrusion. This will mark the
matching location for drilling a clearance hole when
assembling the extrusion, panel and handle.
3/4" Min.
1-1/2" Max.
ZKHT1 Trim Kit (For 3/4" Panels)
Support for Custom Handles
Step 1
Temporarily
mount
door panels
Step 2
Locate
position
of handles
• Place the prepared 3/4"custom door panels on the
bottom trim with support bracket tabs inserted into
slots.
• Push the panel back against the steel door, making
sure panel is flush with hinge side trim.
• Determine the desired location of the custom handles
and carefully mark centerlines of the screw holes.
The handles must be located 3/4" to 1-1⁄2" from the
end of the extrusion.
• Again, with both doors closed, check centerlines of
the screw holes to be sure they are parallel to the
edge of the door, and level with opposite door.
34
ZKHT1
INSTALLATION
Loading ...
Loading ...
Loading ...