Loading ...
Loading ...
Loading ...
EN
51
Cleaning and Maintenance
www.bora.com
Cleaning in the dishwasher
Place the components face down in the dishwasher.
No water should be able to gather in the grease filter
components.
Wash on a programme with a maximum temperature
of 65 °C.
If it is no longer possible to clean the grease filter
completely, it must be replaced.
9.3.3 Fitting the components
Assembling the grease filter unit
INFO It is not necessary to apply pressure when
assembling the components. The grease filter
unit is designed so that the individual parts can
be assembled without force and with no room for
error.
Carefully insert the grease filter into the tray.
Ensure that the lock clicks into place.
Do not force the grease filter into the tray.
If you notice any resistance whilst inserting the grease
filter, you just need to turn it around.
Fitting the grease filter unit
INFO The grease filter unit can only be fully inserted
without resistance if it is facing the right way.
If the instructions are followed correctly, it is
impossible to fit it incorrectly.
Carefully insert the grease filter unit into the cooktop
extractor.
Do not force the grease filter unit into the cooktop
extractor.
If you notice any resistance whilst inserting the grease
filter unit, you just need to turn it around.
Fitting the air inlet nozzle
Insert the air inlet nozzle.
Make sure it is positioned correctly.
9.3.4 Replacing the recirculated air filter
In recirculation mode, an additional activated carbon
filter is used. The activated carbon filter absorbs cooking
odours. The activated carbon filter is installed on the
plinth fan or the duct system.
INFO Regularly replace the activated carbon filter.
The service life can be found in the operating
instructions for the relevant activated carbon
filter.
INFO You can obtain activated carbon filters from your
specialist supplier or by contacting BORA via the
website at http://www.bora.com.
Tilt the air inlet nozzle [1] from its horizontal position.
Remove the air inlet nozzle [1] with your other hand.
Removing the grease filter unit
Fig. 9.2 Removing the grease lter unit
Remove the grease filter unit.
To do this, use the handle inside the grease filter unit.
Disassembling the grease filter unit
Fig. 9.3 Removing the grease lter
Remove the grease filter from the tray.
To do this, push in the 2 locking tabs on each end of
the filter.
9.3.2 Cleaning the components
The air inlet nozzle, grease filter and tray can be cleaned
manually or in a dishwasher.
Disassemble the grease filter unit prior to cleaning.
Manual cleaning
Use a cleaner and degreaser in one.
Rinse the components with hot water.
Clean the components with a soft brush.
Rinse the components well after cleaning.
Loading ...
Loading ...
Loading ...