Loading ...
Loading ...
Loading ...
-
ASSEMBLY INSTRUCTIONS
PREPARING THE STAND
Figure 4.
1. Grab the (9) handle of the stand so that the wheels are on the ground and supporting the
weight of the stand.
2. Press the Quick Release Leg Lock Lever on one of the legs on the side of the handle and
rotate the leg downward until the locking pin clicks into place.
3. Repeat with the other leg on the side of the handle.
4. Lift the stand on the side with the wheels so that the weight is supported by the user and
the already opened legs.
5. Press the Quick Release Leg Lock Lever on one of the legs on the side of the handle and
rotate the leg downward until the locking pin clicks into place.
6. Repeat with the other leg on the side with the wheels.
7. Check to ensure the stand is stable and all of the legs have the locking pins engaged.
FIG 4
Locking Pin
Leg
Quick Release Leg Lock Lever
ASSEMBLING AND INSTALLING MATERIAL SUPPORTS
Figure 5
1. Slide one (13) M6*55 carriage bolt through the square hole in the (4) material support and
extend through the other side.
2. Place the (5) work stop over the end of the bolt.
3. Thread one (11) knob nut over the end of the bolt and tighten to secure.
4. Slide material support rail through the hole in the top of the (6) material support receiver.
5. Insert one (10) knob screw through the small hole on the side of the material support receiver
and tighten to secure.
6. Insert one (20) small screw into the bottom of the work support rail and tighten to secure.
7. Slide the (6) material support receiver over the extension rail so that the extension rail extends
through the opening in the receiver. Position the material support at the desired location on
the extension rail.
8. Insert one (20) small screw into the back of the extension rail and tighten to secure.
9. Repeat with other supports.
Page 7
Loading ...
Loading ...
Loading ...