Loading ...
Loading ...
Loading ...
-Jv I)
/!
I \
ASSEMBLY INSTRUCTIONS
ATTACHING CORD MINDER
Figure 9.
1. Locate leg with 2 pass-through holes.
2. Pass one (23) M5*55 screw through the top hole of the leg and through the (12) plastic cord
minder attachment, making sure that the tip of the cord minder attachment is pointing up
towards the top of the stand.
3. Apply (25) M5 nylon nut and tighten.
4. Pass one (23) M5*55 screw through the (22) cord snap piece then through the body and the
plastic cord minder attachment, making sure that the tip of the cord minder attachment is
pointing down towards the ground.
5. Apply (25) M5 nylon nut and tighten.
FIG 9
M5*55 Screw
Cord Clip
Cord Minder M5 Nylon Nut M5 Nylon Nut Cord Minder
Attachment Attachment
MOUNTING THE MITER SAW TO THE STAND
Figure 10
Use the handles located at the rear of the tool mounts to aid in installing or removing saw and
tool mount assembly.
1. Lift the saw and tool mount assembly, allowing the assembly to tilt slightly toward your body.
2. While still tilted toward you, hook the front edge of the tool mount assembly onto the front
rail of the stand.
3. Lower the tool mount assembly to allow the rear edge of the tool mount to seat fully over
the rear rail.
4. Lock the tool mounts in position by lowering the locking levers.
5. Snap the J-Lock™ clips closed (around the beams) to prevent your mounted tool from
detaching from the MASTERFORCE® Miter Saw Stand.
Page 11
Loading ...
Loading ...
Loading ...