Loading ...
Loading ...
Loading ...
ASSEMBLY INSTRUCTIONS
5. Tighten down the (15) M8 nuts that were placed in the rapid clamp tool mounting rail and
rapid clamp tool mount base in Step 3.
6. The rapid clamp tool handle and tool storage arms can be placed anywhere along the
Rapid Clamp Tool Mounting Rail. Hold the rapid clamp tool handle and tool storage arms
in place using two (14) M8*20 carriage bolts and two (15) M8 nuts.
NOTE: If the tool has holes that do not line up with the slots in the tool mounts, then
use the Offset Mounting Brackets (see Figure 8).
FIG 6
l
g
Rapid Clamp Tool
Mount Base
Storage Handle
Rapid Clamp Tool
Mounting Rail
-
ATTACHING YOUR MITER SAW OR OTHER BENCHTOP POWER TOOL
Figure 7.
Various bench top tools can be used with your Miter Saw Stand by attaching them to the
Rapid Clamp Tool Mounts. Always position the saw to achieve maximum balance and
stability. All four corners of the saw must be bolted to the tool mounts before use. Make sure
bolts do not extend above the table of the miter saw.
1. Unplug the saw and lock the saw arm in the down position.
2. Place a tool mount underneath the saw, aligning the mounting holes on the miter saw base
with the slot in the top of the tool mount.
Page 9
Loading ...
Loading ...
Loading ...