Loading ...
Loading ...
Loading ...
FIG 7
-
-
ASSEMBLY INSTRUCTIONS
3. Feed one (16) M8*60 carriage bolt up through both the tool mount and a mounting hole
in the saw.
4. Secure in place using a (17) flat washer, (18) spring washer, and (15) M8 nut.
5. Repeat through the other end of the tool mount.
6. Place the second tool mount underneath the other side of the saw, aligning the mounting
holes on the miter saw base with the opening in the tool mount.
7. Install (16) M8*60 carriage bolts as previously described.
8. After making sure both tool mounts are parallel to each other, finger tighten all four nuts to
hold in position.
NOTE: If the saw has holes that do not line up with the slots in the tool mounts, use the
offset mounting brackets.
OFFSET MOUNTING
Figure 8
Offset mounting bracket for miter saws and/or power tools with an irregular mounting hole pattern.
Instructions: Secure (3) offset mounting brackets as shown using the supplied (16) M8*60
carriage bolts. These brackets can be used on the front or rear of the rapid clamp tool mounts to
accommodate your specific power tool.
FIG 8
Offset Mounting Brackets
Page 10
Loading ...
Loading ...
Loading ...