Loading ...
Loading ...
Loading ...
ASSEMBLY INSTRUCTIONS
FIG 10
J-Lock™ Clip
NOTE: Continue to hold the tool mount assembly with one hand until both levers are
securely locked.
6. Check position and adjust if necessary to make sure the weight of the saw is evenly
balanced over the rails.
7. Ensure the saw is seated and locked in position, then securely tighten the four nuts holding
the saw to the tool mounts.
TO REMOVE SAW FROM STAND
Figure 11
1. Raise the locking levers to unlock the saw and tool mounts.
2. Unsnap the J-Lock™ Clips from around the mounting beams to allow your tool to separate
from your MASTERFORCE® Miter Saw Stand.
3. Lift away from the rear rail of the stand to disengage.
4. With the assembly tilted slightly toward you, lift the assembly to disengage from the front
rail of the Miter Saw Stand.
Page 12
Loading ...
Loading ...
Loading ...