Loading ...
Loading ...
Loading ...
-
ASSEMBLY INSTRUCTIONS
TOOL MOUNT ADJUSTMENT SCREW
Most plastic tool mounts are designed to fit snugly over the stand rails. With the locking levers in
the lowered (locked) position, you should not be able to remove the saw and tool mount
assembly from the rails. If the saw and tool mount can be removed from the rails when the levers
are locked, the tool mount adjustment screws need to be tightened. If the saw and the tool
mount assembly will not fit over both rails, the bracket adjustment screws needs to
be loosened.
NOTE: The saw should be removed from the tool mounts before attempting to tighten or
loosen the tool mount adjustment screws.
TO ADJUST
Figure 13
1. Use a wrench to slightly loosen the nut.
2. Turn the screw with a Phillips screwdriver. Rotate clockwise if the tool mount assembly needs
to be tightened or counterclockwise if the assembly needs to be loosened.
3. Install the tool mount on the Miter Saw Stand rails and lower the locking lever to check
the adjustment.
4. When the correct position is achieved, tighten the nut with a 10mm open-ended wrench
to secure.
5. Repeat steps 1-4 to attach the second tool mount.
FIG 13
Wrench
M6 Nut
Tool Mount
Tool Mount
Adjustment Screw
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage
from various types of commercial solvents and may be damaged by their use. Use clean cloths
to remove dirt, dust, oil, grease, etc.
Page 14
Loading ...
Loading ...
Loading ...