Loading ...
Loading ...
Loading ...
Drolet-DG04905 17
OPERATION
LIGHTING INSTRUCTIONS / MILLIVOLT (SELF GENERATING)
1. Turn the thermostat knob "A" to 7 (maximum setting).
2. From the "off" position, push in gas control knob "B" and hold it in 30
secondes.
3. If you smell gas, STOP! Follow “WHAT TO DO IF YOU SMELL GAS” in
the safety information. If you don’t smell gas, go to the next step.
4. Hold in knob "B" and turn it counterclockwise towards the pilot position.
You should hear the spark/click during the ignition. You will see the
flame through the 3 viewing holes in the front jacket.
5. Repeat step "4" until you see a flame in the viewing holes
6. Continue to hold the gas control knob in for about one (1) minute after
the flame is lit.
7. Release the gas control knob "B". Pilot should remain lit. If pilot goes
out, repeat steps 4 thru 6.
- If knob does not pop up when released, STOP and immediately call your service technician or
gas supplier.
- · If the pilot will not stay lit after several tries, turn the gas control knob to “OFF” and call your
service technician or gas supplier.
8. When the pilot is stably on, turn the knob to the main burner ignition in On position and check that
the burner ignites.
9. The burner will stay on (changing its power automatically) until it reaches the temperature setting,
at which point the burner will turn off leaving only the pilot still on, ready to ignite the burner again
as soon the temperature falls. If you experience problems with ignition or operation, or the pilot
light goes out, the heater will go into SHUTDOWN mode, and will automatically shut off the gas
supply. Wait for 1 minute for the thermocouple interlock to cool down before repeating the ignition
procedure. This operation can only be repeated 3 times. If the heater doesn’t start after three
attempts, set the master switch to OFF and contact service technician or gas supplier.
"B"
"A"
TO TURN OFF GAS TO APPLIANCE
1. Set the thermostat to it’s lowest setting.
2. "Turn off all electric power to the appliance if service is to beperformed"
3. Open cabinet door.
4. Push in gas control knob slightly and turn clockwise to "OFF".
5. Do not force.
6. Close cabinet door.
Loading ...
Loading ...
Loading ...