Loading ...
Loading ...
Loading ...
Drolet-DG04905 15
WALL INSTALLATION
1. Remove the jacket (12) from the heater (13)
(see instructions below)
2. Fit the O-Ring gasket (14) around the flange
of support (2).
3. Align and insert the two nuts of bracket (1)
in the coresponding holes in the heater
(13). Make sure the bottom of the heater is
supported by the lower flange of the support
(2). Secure the heater to the support with two
nuts (15). Tighten the nuts (15) until the rear of
the heater slightly compreses the gasket (14).
If it is not compressed enough, the system
will not be airtight which can be hazardous
and cause malfunctions.
REMOVING AND REINSTALLING THE JACKET
REMOVING THE JACKET
1. Remove the tray (3).
2. Undo the screws (2) securing the jacket.
3. Remove the external jacket (1) by lifting it
completely off.
REINSTALLING THE JACKET
1. Fit it against the edge of the frame, slide
the front of the jacket onto the front of
the frame and push it fully.
2. Hold it in place and secure it to the heater
with the screw (2).
3. Restore the tray (3).
12
13
2
1
15
15
14
12
13
2
1
15
15
14
3
2
1
Loading ...
Loading ...
Loading ...