Loading ...
Loading ...
Loading ...
Page 19
OPERATION
WARNING:
Always remove the
battery pack from the tool when assembling
parts, changing blades and making
adjustments. Failure to obey this warning
could cause serious personal injury.
2. Using a carpenter’s square, check the
squareness of the saw blade to the base of
the saw.
TO ADJUST 0° BEVEL
STOP (FIG. 17)
FIG. 17
0° bevel stop
adjusting screw
1. Remove the battery pack from the saw.
2. Loosen the bevel adjustment knob.
3. Turn over the saw on a workbench.
4. Using a hex wrench(sold separately), turn
the 0°bevel stop adjusting screw until the
base is square with the saw blade.
POCKET CUTTING (FIG. 18)
Lower
blade guard
Lower blade
guard lever
Guideline
FIG. 18
WARNING:
Always adjust the bevel
setting to zero before making a pocket cut.
Attempting a pocket cut at any other setting
can result in a loss of control of the saw,
which can result in serious injury.
1. Remove the battery pack from the saw.
2. Adjust the bevel setting to zero.
3. Set the blade to the correct blade
depth setting.
4. Place battery pack onto the saw.
5. Swing the lower blade guard up using the
lower blade lever.
NOTICE: Always raise the lower blade
guard with the lever to avoid serious injury.
6. Hold the lower blade guard up by the lever.
7. Rest the front of the saw base at against
the workpiece with the rear handle raised
so the blade does not touch the workpiece.
8. Start the saw and let the blade reach full
speed.
9. Guide the saw into the workpiece and
make the cut.
Loading ...
Loading ...
Loading ...