Loading ...
Loading ...
Loading ...
Page 14
OPERATION
LOCK-OFF BUTTON (FIG. 7)
FIG. 7
Lock-off button
Trigger switch
The lock-off button reduces the possibility
of accidental starting. The lock-off button is
located on the handle above the trigger switch.
The lock-off button must be depressed before
you squeeze the trigger switch.
NOTICE: The lock-off button can be
operated from either the left or right side.
STARTING/STOPPING
THE SAW (FIG. 7)
To start the saw:
1. Depress the lock-off button.
2. Depress the trigger switch. Always let the
blade reach full speed, then guide the saw
into the workpiece.
To stop the saw:
1. Release the trigger switch.
2. After you release the trigger switch, allow
the blade to come to a complete stop. Do
not remove the saw from the workpiece
while the blade is moving.
DEPTH OF CUT
ADJUSTMENTS (FIG. 8)
FIG. 8
Always keep the correct blade depth
setting. The correct blade depth setting for
all cuts should not exceed 1/4 inch below
the material to be cut. Excess blade depth
will increase the chance of kickback and
cause the cut to be rough. One blade tooth
below the material to be cut works best for
efcient cutting action.
TO ADJUST BLADE DEPTH
1. Remove the battery pack from the saw.
2. Loosen the depth-of-cut adjustment lever.
3. Determine the desired depth of cut.
4. Hold the base of the saw at against the
edge of the workpiece and then raise or
lower the saw until the indicator mark on
the bracket aligns with the desired depth-
of-cut mark.
5. Securely tighten the depth-of-cut
adjustment lever.
Loading ...
Loading ...
Loading ...