Masterforce 5406.2 20-Volt Cordless 6-1/2" Circular Saw - Tool Only

User Manual - Page 17

For 5406.2.

PDF File Manual, 28 pages, Read Online | Download pdf file

5406.2 photo
Loading ...
Loading ...
Loading ...
Page 16
OPERATION
WARNING:
ALWAYS clamp and
support workpiece securely. ALWAYS
maintain proper control of saw. Failure to
clamp and support workpiece and loss of
control of saw could result in serious injury.
INTEGRATED RIP AND
CROSSCUT RULERS
Marked along the base across the front of
the saw is a ruler for measuring repetitive
cuts. The markings on the front of the base
are in increments of 1/2-inch (12.7 mm).
NOTICE: The distance from the line of cut
to the guideline is the amount you should
offset the guide.
MAKING CROSS CUTS AND RIP CUTS (FIG. 11)
FIG. 11
Line of cut
0°indicator
When making a cross cut or rip cut, align
your line of cut with the left side of the notch
by the 0
0
indicator. Since blade thicknesses
vary, always make a trial cut in scrap material
along a guideline to determine how much, if
any, the guideline must be offset to produce
an accurate cut.
WARNING:
Do not bind the blade in
the cut. It could cause the saw to “kickback”
towards you, which could result in serious
injury.
WARNING:
If the blade comes
in contact with the workpiece before it
reaches full speed, it could cause the saw
to “kickback” towards you, which could
result in serious injury.
Loading ...
Loading ...
Loading ...